6 steps to paint baseboards with carpet installed. Run the brush about 1/4 inch from the edge.
Run your tape along the entire length of the carpet, beneath the baseboards you intend to paint.
How to paint baseboard molding with carpet. This method is straightforward, though time consuming. Apply paint to the middle of the molding to get some of the paint off of the brush. The best height for baseboard when carpet is going to be installed is 3/8.
There typically is a decent gap between the baseboard and the carpet that you will see once you are able to push down the carpet (and push back the tape). I then take that extra tape on the baseboard and use the paint edger to tuck the tape under the carpet pulling the carpet toward you as you tuck. Do not press the tape onto the baseboard, we’re not done with the tape yet.
If your tape does not seem to stick very well to the carpet,. For baseboards on carpeted floors. Removing baseboards before installing carpet isn’t absolutely necessary, but it can make the task easier in some aspects.
To better protect the carpet, run another strip of tape next to the first and add a tarp to avoid paint. If your carpet is glued, this is not going to be the best method because it will be difficult to pull up the carpet without damaging it. Next i continue working my way across the whole area to be painted.
This will allow you to paint below the carpet line in the baseboard. Work on small sections of baseboard at one time. Pull the carpet back from the baseboard.
Directions for painting baseboards with carpet: Do not remove the tape until the paint is. Continue step 1 as you slide your paint shield down the baseboards.
Raised base makes it easier for the carpet installer to install any thickness of carpet and the edges look better. Then i take a smaller putty knife and push the top of the tape down between the baseboard and the carpet. Place your paint shield in between the baseboard and the carpet.
Paint the bottom of your baseboard carefully. Lay a tarp or plastic sheet over the carpet, including the edge of the carpet where the tape has been placed.now when you paint the wall it’s much easier to free hand a.of tape running past the carpet that overlaps onto the baseboard. A thick carpet will tuck nicely along the baseboard and so will a thin low profile carpet such as a berber or thin looped carpet.
Then, cut in along at the top of the molding using the tapered edge of the brush. Paint with your 3” paintbrush. I get a roll of packing tape, and roll out a foot or two touching the carpet and going up a little over an inch of the baseboard.
Once you’ve painted the top and middle of your board, dip your brush into the paint tray and tap it repeatedly to remove most of the paint. This modal can be closed by pressing the escape key or activating the close button. Use painter’s tape or regular masking tape and make sure you tape it properly to the carpet and tuck at least 1/4” of the tape under the baseboard to make sure that the paint can’t get into the carpet in any way.
If the baseboards are not removed, the tack strips of the carpet will be laid up until the edge of the trim. Next, angle it so it pulls the carpet fibers away and leaves you with enough space to insert your paintbrush. 1.) place the paint shield in between the baseboard and the carpet.
Run your 2″ masking tape roughly 1/2 an inch up onto the baseboard. The edge of the carpet is then rolled under the edge of the baseboard trim. When laying the tape, tuck the edge of the tape underneath the edge of the baseboard.