When you feel resistance, wind the snake back. Feed the end of the cable into the toilet,.
In order to use the snake in a drain you using a snake can be a little messy if the toilet is backed up with water.
How to use a plumbing snake on a clogged toilet. This methods is super short term solution. Here is a great youtube video as well on how to use a plumbing snake. A few towels around the toilet should be enough to deal with any messy situations.
Place the end of the snake into the toilet. Set the electric snake to ‘reverse’ and start pulling back the coil. Otherwise, your clog will come back and with a vengeance.
Once you're done with the blockage, you should use the handle to retract the coil. Unfurl the snake and lower the bulbous metal end into the toilet bowl. You will need to get a toilet auger to fully clear your clog.
A toilet auger is designed with a special guard which allows you to safely introduce the auger head into the drain without scratching the bowl. At the end of the snake is a curved hook, which will help break up and grab debris that has accumulated in the pipes. How to use a toilet snake properly | clogged blocked toilet repair using toilet.
Flush the toilet to see if the clog has loosened. Learning how to snake a toilet could save be a lifesaver when you've got a clogged toilet and nowhere else to turn. Stick the snake right into the toilet where you put the plastic side into the hole.
Using an ordinary drain snake to unclog a toilet will leave it with very ugly scratch marks. You can hold the plastic handle with one hand and push the metal snake. How to snake a toilet.
How to snake a clogged toilet with a hanger is an el cheapo special. Lay a couple of towels around the base, position a large bucket nearby and put on rubber gloves. To properly snake a toilet:
To unclog toilets that couldn't be fixed with a plunger, use a toilet auger. This piece of equipment is very flexible, and has a long metal rope with a metal spiral ending. Use the handle to uncoil the snake cable down the pipe toward the main drain.
Begin the feeding the snake into the mouth of the drain. You can insert it and push it to remove the stuff that has caused the blockage in the toilet drain. If you haven’t removed the p trap, you may want to run a small stream of cold water while you snake the drain line to help flush out whatever is causing the blocked drain.
Place the head of the augur in the toilet bowl. Use a flashlight to shine a bright light down the vent pipe to look for further blockage you can reach. So, make sure to put a good amount of the plastic handle into the toilet’s hole before pushing in the metal part.
Applying to much force can damage plumbing pipes. How to use a plumbing snake on a clogged drain. It is also sometimes called a toilet jack.
If you removed the p trap, then insert the snake into the clogged drain line. You must be very careful when using a plumber’s snake. Slowly turn the handle of the augur clockwise.
A drain snake is an affordable plumbing tool that can give wonderful results to resolve a clogged toilet drain. Also, be sure to cover your hands with rubber gloves and have a large bucket nearby. Prepare the area around the toilet for any likely mess.
To do it yourself, start by clearing debris from around the pipe. Once you get rid of the toilet clog (test it out by flushing), you can now start removing the snake from the drain. If you can see but can't reach, run a plumber's snake down the vent pipe.
Do this gradually and slowly. How to snake a toilet with a hanger. Only works with crazy simple and shallow clogs.
If the toilet is still clogged, wind the snake back in and repeat until the clog is broken up and the toilet flushes easily. A plumbing snake is a long and flexible type of auger designed to eliminate blockages from drainpipes. Also called a plumbing snake, this flexible coil of wire is designed to extend into pipes and clear obstructions without damaging the plumbing.
This is how you do it.